How To Cut A Glass Without A Diamond CutterDip a piece of common string in alcohol and squeeze dry, or as dry as it will get without dripping. This string should then be placed on the already marked glass and tied tight. Light the string and let it burn off.
Immediately, while the glass is still hot, plunge it into cold water. Be sure the container of water is large enough to let the glass to completely submerge, as well your arm up to the elbow, so as to deaden the vibration when you strike the glass.
Strike the glass with your other hand above the line using a wooden stick and hitting a sharp stroke. This quick, sharp stroke will break the glass where it has been weakened by the burning string, as if done by a regular glass cutter.
This meth§od may be used to cut bottles in any shape, and to make vases. You can perform many such cuttings on glass.
METHOD 2 - This method rarely fails to break the glass cleanly, in the exact place you want it broken. First, scratch the glass with the corner of a file or a sharp engraving tool. Have a piece of wire bent to the desired shape you want to cut the glass. Heat the wire until it is red hot and lay it upon the scratch.
Immerse the glass in cold water just deep enough to come to a level with the wire, but not quite covering it. The glass will break cleanly.
HOW TO CUT GLASS WITH SCISSORS: To do this you must place the glass under water completely, then with a pair of ordinary scissors, proceed to cut the glass as you would paper or cloth. This method is, or course, not as smooth a job as the methods described above.
The edges will not be as smooth, but for getting a piece of glass down to a size and where the edges are not needed to be smooth, this method is satisfactory.
HOW TO DRILL GLASS: Get a piece of steel wire and file the wire to the shape of a drill. The wire-drill must be tempered as follows: Heat the end of the wire-drill on a flame until it is dull red, then place it in metallic mercury.
The wire-drill, tempered in this manner, will bore through glass as easily as through soft metal. When drilling in glass, always use oil of turpentine with a little camphor to lubricate the wire-drill. As you drill, be careful not to drill all the way through from one side, as you will break the glass this way. Drill part of the way, or almost through, then drill from the opposite side to finish. Or, if you cannot do this, as when you are drilling bottles, etc., fill these bottles with water or place the glass in water.
CAUTION: When you make the drill, do not make the cutting edges so sharp or too acute. The drill will cut slowly, but you will have better holes with less breakage. (free article archive)
Linkback:
https://tubagbohol.mikeligalig.com/index.php?topic=14118.0
Topic: How To Cut A Glass Without A Diamond Cutter (Read 1047 times)